Dimplex SF2603 Guía de usuario

PRACTICAL USER’S GUIDE FOR THE DIMPLEX ELECTRIC FIREPLACE WITH REMOTE CONTROL Valued Customer, We are pleased that you have

BFIGURE 10A. MAIN ON/OFF SWITCH The ON/OFF SWITCH supplies power to all fireplace functions (Heater/Flame). B. FLAME ACTION CONTROL Turn the flame a

CAUTION If you need to continuously reset the heater, unplug the unit and call your local dealer. REMOTE CONTROL USAGE The fireplace is supplied wit

MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.

CAUTION Even though the glass is safety glass it may break if bumped, struck or dropped. Care must be taken when handling the glass. HELPFUL HINTS I

CAUTION Do not exceed 25 watts per lamp. To reassemble lamp area 1. Replace the glass and hold it in place at the top. 2. Fasten retaining clip to

TWO YEAR LIMITED WARRANTY Products to which this limited warranty applies This limited warranty applies to the following models of your newly purchase

What you must do to get service under this limited warranty Defects must be brought to the attention of Dimplex Technical Service by contacting Dimple

What Dimplex and its dealers and service agents are also not responsible for: IN NO EVENT WILL DIMPLEX, OR ITS DIRECTORS, OFFICERS, OR AGENTS, BE LIAB

QUICK REFERENCE GUIDE FOR THE DIMPLEX ELECTRIC FIREPLACE 1. Before using the electric corner wall mounted fireplace verify: • Are the circuit break

CONTENTS PAGE 1 Important Instructions PAGE 2 Model and Serial Number Information PAGE 3 Site selection and prepar

IMPORTANT INSTRUCTIONS SAVE THESE INSTRUCTIONS PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautio

Model Number Serial NumberModel Number Label Serial Number LabelModel Number Label Serial Number LabelIMPORTANT INSTRUCTIONS If you have any question

SITE SELECTION AND PREPARATION This section provides easy step by step instructions for selecting a location and preparing the site to install the fi

NOTE The fireplace insert must be installed on a hard surface. NOTE A 15 AMP, 120 VOLT circuit is required. A dedicated circuit is preferr

WARNING Construction and Electrical Outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, e

OPERATION This section will explain the function of each convenient control. 1. To access the controls, open the upper grill by pull